Skip to content

Home / Machines / Roller Conveyor Shot Blasting Machine for Bridge Steel Structures

Roller Conveyor Shot Blasting Machine for Bridge Steel Structures

Through-type roller conveyor shot blasting machine that cleans H-beams, box girders and gusset plates continuously, removing mill scale, weld spatter and rust ahead of primer and coating.

Read product details
Roller Conveyor Shot Blasting Machine for Bridge Steel Structures

Product description

Why bridge steel runs through a roller conveyor line

Bridge structures arrive as long H-beams, box girders, gusset plates and stiffeners. Their webs and flanges carry mill scale, weld spatter and rust that must come off before a primer can hold. A through-type roller conveyor moves each segment horizontally over powered rollers, so the blast cabinet surrounds the profile on all sides while the piece keeps travelling. The result is a steady, repeatable surface instead of the patchy finish you get from manual blasting of large fabrications.

How the machine is built around the workpiece

  • Multi-directional turbine coverage — blast wheels mounted above, below and at the sides treat webs, flanges and edges in a single pass, reaching surfaces a top-mounted head cannot.
  • Heavy roller load capacity — the conveyor is sized for thick plate and long segments, with adjustable roller spacing to keep short stiffeners stable.
  • Variable pass speed — conveyor speed sets dwell time, so the same machine handles thin gusset plates and thick box-girder webs without re-rigging.
  • Integrated abrasive recovery and dust extraction — spent abrasive is separated and returned, while dust is pulled out at the cabinet to keep the coating shop clean.

Finishing quality and where it stops

The aim is a uniform SA 2.5 finish with an anchor profile the primer can grip, so downstream paint or zinc coating does not peel at weld toes and cut edges. Coverage is set by turbine power, wheel position and pass speed, all matched to the steel section being run.

Where the geometry stops cooperating — deep box sections, tight internal corners, or very short pieces that tip on the rollers — the through-type layout reaches its limit, and a hook, table or custom fixture is the better answer. Final parameters are confirmed after reviewing the steel sections, lengths and required finish.

DEFINE THE CONFIGURATION.

ParameterValue
WorkpieceBridge H-beams, box girders, gusset plates and stiffeners
HandlingThrough-type roller conveyor, continuous pass
Surface removalMill scale, weld spatter, rust and old coating
CoverageTurbines above, below and at both sides of the profile
Finish targetUniform SA 2.5 with a coating-ready anchor profile
ConfigurationReviewed against section size, length and required finish

BRING US YOUR WORKPIECE.

Share a photo or drawing, material, maximum dimensions and expected output. These details help us review a suitable configuration.

Send project requirements

Related articles

Industry Applications

Match workpiece handling, blasting configuration and production flow to your application.

Explore industry applications